It has been confirmed that Godiag GT105 full version works well with Autel MaxiPRO MP808Z-TS to perform diagnosis and TPMS functions.
For the first time to use Autel MP808Z-TS diagnostic scanner, the internet connection is required.
Before using, make sure connect the device with WiFi, and follow the on-screen prompts to upgrade and install the Personal Center, after installation, register an Autel account and bind device with SN and password. After binding, download the related software on tablet.
Now, the Autel MP808Z-TS scanner is ready to use with Godiag GT105.
- Diagnose VW
- Read Ford TPMS
- Diagnose VW
Take out the VCI behind the MP808Z-TS tablet
Connect it with GODIAG GT105, Full Protocol OBD2 Universal Jumper and ECU correctly
Start to diagnose the vehicle
As the ECU used is not an ordinary OBD2 protocol, So EOBD cannot read it. It shows the error “Device unable to communicate with the control unit”.
In this case, we can choose the car software to diagnose.
Select Volkswagen in the main menu
Then tap System selection>> Diagnosis>> Control unit>> 01- Engine Control Module 1
Read Trouble codes- OK
Erase codes- OK
View live data- OK
- Read Ford TPMS
Tap “TPMS” in the main menu
Choose the corresponding car model, and tap “Manual selection”
Select the car model and year
Put the MX sensor at the upper right corner of the tablet and tap “Check MX-Sensor” to inquiry the MX Sensor information
The sensor ID is detected, that means the sensor has been programmed.
We change another blank sensor to use, and there is no ID detected.
Alright, it’s the whole process to use Autel MP808Z-TS and Godiag GT105 with Full Protocol Obd2 Jumper to diagnose and identify MX sensor. Easy and fast!