Question:
Hello, i would like to read the ecu on the table using obd with FoxFlash ECU programmer. A cable from mpps is enough, or is it better to add and buy a set with the possibility of changing pianos.
Suggestion 1:
It’s your choice. They all perform the same outcome.
Suggestion 2:
I use godiag. They are good and some nice features.
The godiag breakout box has 2 versions: GT100 and GT100+. They both show voltage, but the + version shows amps. Which comes in handy, and the breakout box comes with a pin out harness, so it will do it both ways you’re looking for.
Godiag also has a breakout cable- Godiag full protocol obd2 jumper, has a switch for 12v switched power and also a switch for pin 4/5 ground.
Both are good, but like I said the breakout box has the harness pin out also. It's definitely worth $100.
Available links to get Godiag OBD2 Breakout box at godiagshop.com:
GODIAG GT100: https://www.godiagshop.com/wholesale/godiag-gt100-obdii-break-out-box-ecu-connector.html
GODIAG GT100+:
https://www.godiagshop.com/wholesale/godiag-gt100-new-generation.html
GODIAG Full Protocol OBD2 Jumper Adapter:
https://www.godiagshop.com/wholesale/godiag-full-protocol-obd2-jumper-adapter.html